This topic covers atomic structure, the periodic table, properties and states of matter, bonding, reactions, solutions, and acids, bases and pH. Know the definitions cold, and practice the short calculations: particle counts, density, balancing, dilution and pH.
Atomic structure
- Protons (charge +1) and neutrons (no charge) sit in the nucleus and each have a mass of about 1 amu; electrons (charge −1) sit outside the nucleus and are far lighter, about 0.00055 amu.
- Atomic number (Z) = number of protons; it identifies the element, and in a neutral atom it also equals the number of electrons.
- Mass number (A) = protons + neutrons, so neutrons = A − Z.
- Isotopes are atoms of one element with different numbers of neutrons: carbon-12 has 6 neutrons and carbon-14 has 8.
- An atom that loses electrons becomes a positive ion (cation); one that gains electrons becomes a negative ion (anion).
- Average atomic mass is a weighted average: multiply each isotope's mass by its fraction of the atoms and add, so the result lies closest to the most common isotope.
Example
Zinc has atomic number 30. How many protons, neutrons and electrons are in a Zn²⁺ ion of zinc-65?
Solution
Protons = Z = 30. Neutrons = 65 − 30 = 35. A neutral atom has 30 electrons; the 2+ charge means 2 were lost, so electrons = 30 − 2 = 28.
The periodic table and its trends
- Elements in the same group (column) have the same number of valence (outermost) electrons, so they react in similar ways; every alkali metal in group 1 has one.
- Atomic radius increases down a group and decreases from left to right across a period.
- First ionization energy, the energy needed to remove an electron, increases across a period and decreases down a group: noble gases have the highest values and alkali metals the lowest.
- Electronegativity, an atom's pull on shared electrons, also increases across a period and decreases down a group; fluorine has the highest value.
- Metals lose electrons easily, and nonmetals tend to gain them.
Example
Arrange magnesium (Mg, period 3, group 2), chlorine (Cl, period 3, group 17) and calcium (Ca, period 4, group 2) from smallest to largest atomic radius.
Solution
Mg and Cl share period 3, and Cl is farther right, so Cl is smaller than Mg. Ca is directly below Mg in group 2, so Ca is larger than Mg. Order: Cl < Mg < Ca.
Properties and states of matter
- A solid keeps a fixed shape, a liquid flows to fit its container, and a gas spreads to fill any container, taking its shape and volume.
- Pure substances are elements (cannot be broken down chemically) or compounds (two or more elements combined); mixtures are homogeneous (solutions) or heterogeneous.
- Density, color, hardness, and melting and boiling points are physical properties: you can measure them while the substance stays the same substance.
- Physical changes such as melting, boiling and dissolving sugar change form, not identity.
- Chemical properties such as flammability, toxicity and acidity describe how a substance changes into other substances; burning, rusting and a banana turning brown are chemical changes.
- Density = mass ÷ volume, and a sinking object's volume equals the volume of water it displaces.
- Phase changes: melting (solid → liquid), freezing (liquid → solid), vaporization (liquid → gas), condensation (gas → liquid), sublimation (solid → gas, as dry ice does), deposition (gas → solid).
- Melting, vaporization and sublimation absorb heat (endothermic); freezing, condensation and deposition release heat (exothermic).
- Temperature stays constant during a phase change: a mixture of ice and water stays at 0 °C until all the ice has melted.
Example
A 27.0 g stone is dropped into a graduated cylinder, and the water level rises from 20.0 mL to 30.0 mL. What is the stone's density?
Solution
Volume = 30.0 mL − 20.0 mL = 10.0 mL. Density = 27.0 g ÷ 10.0 mL = 2.70 g/mL.
Chemical bonds and attractions between molecules
- An ionic bond is the attraction between oppositely charged ions, formed when a metal gives electrons to a nonmetal, as Na⁺ and Cl⁻ do in sodium chloride.
- Ionic compounds form rigid, brittle crystals with high melting points; they conduct electricity when melted or dissolved but not as solids, and they are not made of separate molecules.
- A covalent bond is a shared pair of electrons, usually between nonmetals; equal sharing, as between two identical atoms, is nonpolar, and unequal sharing is polar.
- The larger the electronegativity difference between two atoms, the more polar the bond; a very large difference gives an ionic bond.
- Write an ionic formula so the positive and negative charges cancel: Al³⁺ and O²⁻ give Al₂O₃ (+6 and −6).
- Hydrogen bonds are especially strong attractions between molecules that have H bonded to N, O or F; they are generally weaker than covalent or ionic bonds but strongly affect liquids such as water, giving it a high boiling point.
Example
Magnesium forms Mg²⁺ and nitrogen forms N³⁻. What is the formula of magnesium nitride?
Solution
The smallest total charge both 2 and 3 divide into is 6. Three Mg²⁺ give +6 and two N³⁻ give −6, so the formula is Mg₃N₂.
Chemical reactions
- Reactants are written on the left and products on the right; balance an equation by changing coefficients only, never subscripts, and use the smallest whole numbers.
- Matter is conserved: the total mass of the products equals the total mass of the reactants.
- Synthesis: A + B → AB; decomposition: AB → A + B; single replacement: A + BC → AB + C (as in Zn + 2HCl → ZnCl₂ + H₂); double replacement: AB + CD → AC + BD.
- Combustion (burning) is a fast reaction that releases heat and often light; in a neutralization, an acid and a base typically form a salt and water.
- Reactions happen when particles collide, and they speed up with higher temperature, higher reactant concentration, more surface area (a powdered solid) or a catalyst.
- A catalyst opens a route with lower activation energy, comes out of the reaction unchanged, and does not change the overall energy difference between reactants and products; enzymes are biological catalysts.
Example
Balance: __CH₄ + __O₂ → __CO₂ + __H₂O.
Solution
Carbon: 1 on each side, so CO₂ gets 1. Hydrogen: 4 on the left, so H₂O gets 2. Oxygen on the right is now 2 + 2 = 4, so O₂ gets 2. Balanced: CH₄ + 2O₂ → CO₂ + 2H₂O (1 C, 4 H and 4 O on each side).
Solutions
- A solution is a uniform (homogeneous) mixture in which a solute is dissolved in a solvent, normally the component present in the greatest amount.
- Unsaturated means more solute can dissolve; saturated means the solution holds the maximum at that temperature; supersaturated means it holds more than its solubility, is unstable, and crystallizes when a seed crystal is added.
- Most solids dissolve better as temperature rises, but gases dissolve less as temperature rises (warm water holds less oxygen) and more as gas pressure rises (Henry's law).
- Molarity (M) = moles of solute ÷ liters of solution.
- Dilution adds solvent but not solute, so C₁V₁ = C₂V₂.
- Mass/volume percent = grams of solute per 100 mL of solution; normal saline, 0.9% (m/v) NaCl, has 0.9 g of NaCl in every 100 mL.
Example
How many milliliters of 5.0 M stock solution are needed to make 250 mL of 2.0 M solution?
Solution
V₁ = (C₂ × V₂) ÷ C₁ = (2.0 M × 250 mL) ÷ 5.0 M = 500 ÷ 5.0 = 100 mL. Measure 100 mL of stock and add water to a final volume of 250 mL.
Acids, bases and pH
- Brønsted–Lowry model: an acid donates a proton (H⁺) and a base accepts one; the older Arrhenius model says acids release H⁺ (hydronium) and bases release OH⁻ in water.
- pH = −log[H₃O⁺]; at 25 °C a pH of 7 is neutral, below 7 is acidic, and above 7 is basic.
- Because the scale is logarithmic, each drop of 1 pH unit means 10 times more hydronium.
- At 25 °C, pH + pOH = 14.
- Typical values: gastric juice about 1.5, pure water 7, blood about 7.4, household ammonia about 11 to 11.5.
- A buffer keeps pH nearly steady when a little acid or base is added; the carbonic acid–bicarbonate pair buffers the blood.
Example
Solution X has a pH of 2 and solution Y has a pH of 6. How do their hydronium concentrations compare?
Solution
[H₃O⁺] = 10⁻ᵖᴴ, so X has 10⁻² M and Y has 10⁻⁶ M. 10⁻² ÷ 10⁻⁶ = 10⁴, so X has 10,000 times the hydronium of Y.
Key terms
- Atomic number (Z)
- The number of protons in an atom's nucleus; it identifies the element.
- Mass number (A)
- Protons plus neutrons in an atom's nucleus.
- Isotopes
- Atoms of one element with the same proton count but different neutron counts.
- Cation
- A positively charged ion formed when an atom loses electrons.
- Anion
- A negatively charged ion formed when an atom gains electrons.
- Valence electrons
- Electrons in an atom's outermost shell, which largely decide how it reacts.
- Electronegativity
- How strongly an atom attracts shared electrons toward itself; highest for fluorine.
- Ionic bond
- Electrostatic attraction between oppositely charged ions, typically a metal cation and a nonmetal anion.
- Covalent bond
- A bond in which two atoms share a pair of electrons, usually between nonmetals.
- Hydrogen bond
- Strong attraction between molecules that have H bonded to N, O or F.
- Chemical change
- A change that produces one or more new substances, such as burning or rusting.
- Sublimation
- A direct change from solid to gas without melting, as with dry ice.
- Exothermic
- Releasing heat to the surroundings, as freezing and condensation do.
- Catalyst
- A substance that speeds a reaction by lowering activation energy without being used up.
- Molarity (M)
- Moles of solute ÷ liters of solution.
- Supersaturated solution
- An unstable solution holding more dissolved solute than its normal solubility allows.
- pH
- −log[H₃O⁺]; below 7 is acidic, 7 is neutral and above 7 is basic at 25 °C.
- Buffer
- A solution that resists pH change when small amounts of acid or base are added.
- Brønsted–Lowry acid
- A substance that donates a proton (H⁺) to another substance.
Common mistakes
- Confusing the atom's numbers. Atomic number is protons only; mass number is protons plus neutrons; isotopes differ only in neutrons.
- Getting ion charges backward. A 2+ ion has lost 2 electrons, so it has 2 fewer electrons than protons, not 2 more.
- Reading pH as a linear scale. Two pH units is a 100-fold difference, not 2 or 20 times, and the lower pH has more hydronium.
- Calling dissolving, melting or boiling a chemical change. Only changes that make new substances, such as burning, rusting or browning, are chemical; boiling point is a physical property.
- Balancing by changing subscripts, or giving the number of atoms instead of the coefficient. Change coefficients only, then recount every element.
- Assuming gases act like solids in solution. Warmer liquids hold less dissolved gas, while most solids dissolve better when warm.
Checked against: Wikipedia, Atom; Wikipedia, Carbon-12; Wikipedia, Carbon-14; Wikipedia, Standard atomic weight; Wikipedia, Valence electron; Wikipedia, Periodic trends; Wikipedia, Ionization energy; Wikipedia, Metal; Wikipedia, Nonmetal; Wikipedia, State of matter; Wikipedia, Chemical substance; Wikipedia, Mixture; Wikipedia, Physical property; Wikipedia, Physical change; Wikipedia, Chemical property; Wikipedia, Chemical change; Wikipedia, Rust; Wikipedia, Food browning; Wikipedia, Density; Wikipedia, Displacement (fluid); Wikipedia, Latent heat; Wikipedia, Sublimation (phase transition); Wikipedia, Ionic bonding; Wikipedia, Ionic compound; Wikipedia, Covalent bond; Wikipedia, Hydrogen bond; Wikipedia, Chemical equation; Wikipedia, Conservation of mass; Wikipedia, Chemical reaction; Wikipedia, Single displacement reaction; Wikipedia, Combustion; Wikipedia, Neutralization (chemistry); Wikipedia, Reaction rate; Wikipedia, Catalysis; Wikipedia, Solution (chemistry); Wikipedia, Solubility; Wikipedia, Supersaturation; Wikipedia, Molar concentration; Wikipedia, Dilution (equation); Wikipedia, Mass concentration (chemistry); Wikipedia, Saline (medicine); Wikipedia, Brønsted–Lowry acid–base theory; Wikipedia, pH; Wikipedia, Buffer solution