This topic covers what technicians do with their own hands and bodies: hand hygiene, nails and jewelry, eating and drinking rules, how people and items move through the department, and how to lift, push and set up work without injury. Know the CDC and OSHA rule behind each habit, not just the habit.
Hand hygiene: which method, and when
- CDC: when hands are not visibly soiled, alcohol-based hand sanitizer is preferred in most clinical situations.
- When hands are visibly soiled, for example after a glove tears during manual cleaning, wash with soap and water. Sanitizer does not remove visible soil.
- Sanitizer: use enough to cover every surface of both hands and rub until dry, which should take about 20 seconds. Do not wipe it off or rinse it away.
- Soap and water: rub vigorously for at least 15 seconds, then rinse and dry with a disposable towel.
- Plain water alone is not hand hygiene, and a surgical scrub with a brush is for surgical hand antisepsis, not routine care.
- Clean hands right after removing gloves, even gloves that look intact. Gloves can have tiny defects, and hands get contaminated as gloves come off.
- Gloves never replace hand hygiene. Wiping gloves with sanitizer, or putting on a fresh pair over unwashed hands, does not count.
Nails, rings and personal items
- CDC's 2002 hand hygiene guideline found that workers with artificial nails are more likely to carry gram-negative pathogens on their fingertips than workers with natural nails, both before and after handwashing.
- Artificial nails have also been linked to outbreaks, which is why many sterile processing dress codes ban them.
- The same guideline recommends keeping natural nail tips shorter than 1/4 inch. Polish does not change that.
- Studies cited by CDC found skin under rings carries more microbes than skin on fingers without rings. CDC made no formal ring rule, but this evidence supports department bans on jewelry.
- OSHA's Bloodborne Pathogens standard bans eating, drinking, smoking, putting on cosmetics or lip balm, and touching contact lenses in work areas where exposure is reasonably likely.
- Food and drink may not be kept on counters, shelves or in refrigerators that hold blood or other potentially infectious materials. A closed lid, fresh gloves or a quiet hour does not change this.
One-way flow from dirty to clean
CDC splits central processing into a minimum of three zones: decontamination, packaging, and sterilization plus storage. Items move in one direction only.
- Correct order: decontamination, then preparation and packaging, then sterilization, then sterile storage.
- Items are cleaned before they are inspected and packaged, and packaged before they are sterilized.
- Clean or sterile items never go back into decontamination, and soiled items never pass through clean areas.
- Physical barriers separate decontamination from the other areas to keep contamination from used items inside it.
- Before a technician crosses from decontamination to the clean side, remove the decontamination PPE (gloves and gown) and perform hand hygiene.
- Sterile storage is a limited-access area. CDC notes that traffic is one factor affecting contamination and that the chance of contamination rises the more packs are handled, so people should not browse there "just in case". Shoe covers or a sign-in log do not make extra traffic acceptable.
Ergonomics: fit the job to the person
- OSHA defines ergonomics as fitting a job to a person. It cuts muscle fatigue and the number and severity of work-related musculoskeletal disorders (MSDs).
- It changes the work, not the worker: it is not about training people to tolerate heavier loads or picking only people who can handle a bad setup.
- OSHA ranks controls. **Engineering controls** that physically change the workplace work best, such as moving or replacing a fixed-height table so the work sits within easy reach in a neutral posture.
- **Administrative controls** (rules, job rotation, breaks, reminder signs) come next, and **PPE** such as braces or padding is least effective for ergonomic hazards.
- Working faster is not a fix; it adds repetition without removing the reach.
- Report MSD symptoms early. OSHA notes early reporting limits how severe an injury becomes and helps find the jobs that need changing. Do not hide it with a store-bought brace or by quietly switching hands.
Lifting, storing and moving loads
The NIOSH manual material handling guide gives these rules.
- Get a secure grip and use both hands when you can.
- Keep the load as close to your body as possible; holding it at arm's length strains the back.
- Lift with your legs pushing up, not by bending at the waist with straight legs.
- Move smoothly; avoid jerking.
- Do not twist. Step to one side to turn.
- The **power zone** runs from knee height to shoulder height, with the load held near the body. Store the heaviest sets there, not on the top shelf or the floor-level shelf. A "heavy" label warns but does not reduce strain.
- When there is a choice, push a cart rather than pull it, and push with your whole body, not just the arms and shoulders.
- Do not pile on more trays to save trips; a heavier cart takes more force to move.
Key terms
- Hand hygiene
- Cleaning the hands by washing with soap and water or rubbing in an alcohol-based product.
- Alcohol-based hand sanitizer
- A rub-in hand product preferred by CDC when hands are not visibly soiled; rub until dry, about 20 seconds.
- Visibly soiled hands
- Hands with dirt, blood or other matter you can see; they must be washed with soap and water.
- Gram-negative bacteria
- A large group of bacteria, including Pseudomonas and Klebsiella, found more often on the fingertips of workers wearing artificial nails.
- Bloodborne Pathogens standard
- OSHA rule 29 CFR 1910.1030 that protects workers exposed to blood and other potentially infectious materials.
- Traffic control
- Limiting who enters each area and how people and items move, so contamination does not travel from dirty to clean.
- One-way workflow
- Moving items only from decontamination to packaging to sterilization to storage, never back toward dirty areas.
- Limited-access area
- A space, such as sterile storage, entered only by staff who need to work there.
- Ergonomics
- Fitting a job to a person to reduce fatigue and work-related muscle, nerve and tendon injuries.
- Musculoskeletal disorder (MSD)
- An injury or illness of the muscles, nerves, tendons, ligaments or blood vessels, often from repeated strain.
- Engineering control
- A physical change to the workplace, such as an adjustable table, that removes or reduces a hazard; OSHA's top choice.
- Administrative control
- A rule or procedure, such as job rotation or scheduled breaks, used when physical changes are not enough.
- Power zone
- The safest lifting area: between knee and shoulder height, with the load held near the body.
Common mistakes
- Using sanitizer on visibly soiled hands. Visible soil means soap and water; sanitizer is for hands that look clean.
- Skipping hand hygiene because the gloves looked intact, or sanitizing or changing gloves instead of cleaning hands. Clean hands every time gloves come off.
- Believing a lidded bottle or a fresh pair of gloves makes a drink acceptable in decontamination. OSHA bans drinking and keeping drinks in exposure areas.
- Putting the workflow in the wrong order. It is always decontamination, then preparation and packaging, then sterilization, then storage, and nothing returns to decontamination.
- Choosing a brace, a reminder sign or working faster as the best fix for an ergonomic problem. OSHA ranks changing the workstation (an engineering control) first.
- Storing heavy sets on the top shelf to keep them out of the way, holding loads away from the body, twisting while lifting, or pulling a cart with one hand.
Checked against: CDC, Clinical Safety: Hand Hygiene for Healthcare Workers; CDC, Guideline for Hand Hygiene in Health-Care Settings (MMWR 2002;51 RR-16); OSHA, 29 CFR 1910.1030 Bloodborne Pathogens; CDC, Disinfection and Sterilization Guideline: Sterilizing Practices; OSHA, Ergonomics; OSHA, Ergonomics: Solutions to Control Hazards; OSHA, Ergonomics: Identify Problems; NIOSH/Cal-OSHA, Ergonomic Guidelines for Manual Material Handling (DHHS NIOSH Publication 2007-131)